Mounting Hardware is Included
This mount fits:
Savage Model 10 Short Action Round Rear Receiver
Savage Model 11 Short Action Round Rear Receiver
Savage Model 12 Short Action Round Rear Receiver
Savage Model 14 Short Action Round Rear Receiver
Savage Model 16 Short Action Round Rear Receiver
Savage Model 110 Short Action Round Rear Receiver
Stevens Model 200 Short Action Round Rear Receiver
Please check your mounting screw diameter and hole spacing before placing your order to ensure you select the correct mount. Screw diameter and hole spacing information in pictures and below.
This Savage base will work with any short action round back Savage rifle with an ejection port. It has an extra 3" over the front of the receiver.
Rail
Type: One Piece Picatinny
Machined
from: Domestic 6061 T6 Extruded Aluminum
Finish:
Matte Black Anodizing
Center
Spread: 3.930"
Overall
Length: 8.625"
Height:
.4" (Top of Receiver to Top of Picatinny)
Weight:
2 oz.
Quick
Disconnect Ring Compatible: No
Ambidextrous:
Yes
Torque
Specs: 20 in/lbs
Mounting
Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
Savages without an accu-trigger will require our flat back mount (listed separately).
EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
EGW machines these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/ 