Mounting Hardware is Included

This mount fits:

Savage Model 12 FTR Short Action Round Rear Receiver

Please check your mounting screw diameter and hole spacing before placing your order to ensure you select the correct mount. Screw diameter and hole spacing information.

Rail Type: One Piece Picatinny

Machined from: Domestic 6061 T6 Extruded Aluminum

Finish: Matte Black Anodizing

Center Spread: 3.930"

Overall Length: 8.625"

Height: .4" (Top of Receiver to Top of Picatinny)

Weight: 2 oz.

Quick Disconnect Ring Compatible: No

Ambidextrous: Yes

Torque Specs: 20 in/lbs

Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

This Savage base will work with any short action round back Savage rifle without an ejection port. It has an extra 3" over the front of the receiver.

Savages without an accu-trigger will require our flat back mount (listed separately).

EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

EGW machines these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:

0 MOA - if shooting 0-500 yards

20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov