Mounting Hardware is Included
This mount fits:
Savage MK II with 1-5/8" ejection port
*Please note, older Savage MK II rifles come with a 1-3/8" ejection port and utilize our Savage MK II scope mounts. Please measure the size of your ejection port prior to ordering to ensure the right fit.
Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: 3.345"
Overall Length: 5.882"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
This mount comes standard with a bevel on both sides making it ambidextrous.
EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
EGW machines these in their shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
0 MOA - if shooting 0-150 yards
20 MOA - if shooting 150-300 yards
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.