Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black
Mounting Hardware: Hex head screws and wrench provided
Center Spread: 3.259"
Overall Length: 6.276"
EGW's Winchester 70 mounts will work for any short action, long action, WSM or WSSM mount.
*The Winchester Coyote edition chambered in .243 will require our WSM mount.*
The middle spread is the distance between the two middle holes, center to center, on your receiver. The middle spreads on EGW's Winchester 70 mounts are as follows:
Winchester 70 Short Action: 3.259"
Winchester 70 Long Action: 3.805"
Winchester 70 WSM: 3.514"
Winchester 70 WSSM: 3.225"
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories.
The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights.
EGW's one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
Add EGW's Practical or HD Scope Rings to make it a complete overhaul!
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/