Machined From: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black
Mounting Hardware: Hex Head Screws and Wrench Provided
Fits the Browning BAR and BLR Long Action:
Center Spread: 3.19"
Overall Length: 5.488"
This mount will also fit the Benelli R1 rifles - it will cover the middle hole on their action, but will use the front and back pairs.
Also Fits Browning ShortTrac.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!
We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/