EGW's Tikka T3 mount is made specific to the gun, and will also work with Tikka T3 Lite and T3 X Rifles. The T3X rifle has an extra hole in the receiver that our rail covers up and does not use.
Compatible with:
T3x Superlite Camo
T3x Superlite
T3x Compact
T3x Lite
T3x Lite Stainless
T3x Compact Tactical Rifle
T3x Varmint
T3x Laminated Stainless
T3x Forest
T3x Hunnter Stainless
T3x Hunter
T3 Hunter
T3 Laminated Stainless
T3 Varmint
T3 Super Varmint
T3 Varmint Stainles
T3 Compact Tactical
Modification to the front of the mount is required to fit the Tikka T3X Tac A1. The mount must be cut down to fit behind the forend. This mount is not the same height as the forend.
This mount does not have a recoil lug.
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
EGW's Tikka T3 mount is provided with standard 6-48 screws, as Tikkas produced after 2004 are drilled at tapped for 6-48 screws.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!
EGW machines these in their shop using one of their USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
