0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Ruger
  5. Scope Mounts
  6. EGW Ruger M-77 Short Action 20 MOA (MUST DRILL & TAP RECEIVER) Ambidextrous
EGW Ruger M-77 Short Action 20 MOA (MUST DRILL & TAP RECEIVER) Ambidextrous
EGW Ruger M-77 Short Action 20 MOA (MUST DRILL & TAP RECEIVER) Ambidextrous

EGW Ruger M-77 Short Action 20 MOA (MUST DRILL & TAP RECEIVER) Ambidextrous

Write a Review
Price: $39.00
EGW Evolution Gun Works makes scope mounts and scope bases for most popular rifles in 0 MOA, 20 MOA, 30 MOA, and 40 MOA. Put a scope on your favorite rifle with a quality mount Made In The USA.
Part Number: 46142
Availability:
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black
Mounting Hardware: Hex head screws and wrench provided
Center Spread: 3.875"
Overall Length: 5.882"

This base also fits the Ruger Hawkeye Short Action. 

This mount is sold DRILLED for 8-40 screws and is made specifically for the Ruger M77. This mount will require you to drill and tap your receiver.

*The center spread is the distance between the two middle holes, center to center, on your receiver.

This base sits at approximately 0.4” high.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. 

Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike. This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings. 

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!

EGW machines these in their shop using one of their USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.


CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Recently Viewed Items