*The center spread is the distance between the two middle holes, center to center, on your receiver.
This base sits at approximately 0.4” high.
*********************
Fits Pre-2010 Models #46600
Please confirm that your hole spacing measurements match what we have published. The distance between the 2nd and 3rd hole is the critical measurement. Your measurement should either be:
2.361" - This means the rail that you are currently viewing is the CORRECT RAIL FOR YOU!
.787" - If your 2nd to 3rd hole distance measures .787" you will need EGW's SKU 46603.
The measurements are also listed in the second image above and in the product specs below.
Mounting Hardware is Included
This mount fits:
CVA Inline Muzzleloader
CVA Accura Muzzleloader
***********************
If your CVA is a 2010 or newer model, or any Centerfire, please choose EGW's CENTERFIRE mount (item number 46601).
If your muzzle loader is 2009 or older, please choose EGW's MUZZLE LOADER mount.
The CVA V2 mount is item number 46603.
***********************
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!
We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.