0 Items
  1. Home
  2. Firearm Accessories
  3. Rifle Scope Bases
  4. CVA
  5. EGW CVA V2 Muzzleloader Picatinny Rail Mount
EGW CVA V2 Muzzleloader Picatinny Rail Mount
EGW CVA V2 Muzzleloader Picatinny Rail Mount

EGW CVA V2 Muzzleloader Picatinny Rail Mount

3 Review(s) Write a Review
Price: $29.00
EGW Evolution Gun Works makes scope mounts and scope bases for most popular rifles in 0 MOA, 20 MOA, 30 MOA, and 40 MOA. Put a scope on your favorite rifle with a quality mount Made In The USA.
Part Number: 46603
Fits Post-2010  #46603 

Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: 787"
Overall Length: 5.488"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #8-40 X 1/4 Screws and T-10 Bit Included

Please confirm that your hole spacing measurements match what we have published. The distance between the 2nd and 3rd hole is the critical measurement. Your measurement should either be:

.787" - This means the rail that you are currently viewing is the CORRECT RAIL FOR YOU!
2.361" - If your 2nd to 3rd hole distance measures 2.361" you will need our SKU 46600.

Fits Post-2010  #46603 

The measurements are also listed in the second image above and in the product specs below.

Mounting Hardware is Included

This mount fits:
CVA Accura V2
CVA Centerfire
CVA Wolf 50 Cal Muzzleloader
Bergara B13

Please measure your hole spacing to see which CVA mount it matches with. Older model Muzzleloaders (PRE 2010) require the mount

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.

This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings. 

Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!

We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.

CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Recently Viewed Items