0 Items
  1. Home
  2. Manufacturers
  3. EGW Evolution Gun Works
  4. EGW Savage Model 99 Picatinny Rail 0 MOA (Factory Drilled And Tapped)
EGW Savage Model 99 Picatinny Rail 0 MOA (Factory Drilled And Tapped)
EGW Savage Model 99 Picatinny Rail 0 MOA (Factory Drilled And Tapped)

EGW Savage Model 99 Picatinny Rail 0 MOA (Factory Drilled And Tapped)

Write a Review
Price: $69.00
EGW Evolution Gun Works makes scope mounts and scope bases for most popular rifles in 0 MOA, 20 MOA, 30 MOA, and 40 MOA. Put a scope on your favorite rifle with a quality mount Made In The USA.
Part Number: 80350
Availability:
Mounting Hardware is Included

This mount fits:
Savage Model 99

This mount only fits guns that are factory drilled and tapped or have been previously drilled and tapped to the 1 piece Leupold/Redfield pattern in the correct location.

Savage Model 99s in .308 should also be factory drilled and tapped.

If "Savage" and "Model 99" are located on the left side of the receiver, then it would indicate your gun is factory drilled and tapped.

Please check your mounting screw diameter and hole spacing before placing your order to ensure you select the correct mount.

Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Hardcoat
Center Spread: 3.76"
Overall Length of Mount: 5.882"
Height: .35" (Top of Receiver to Top of Picatinny)
Weight: 2.5 oz
Quick Disconnect Ring Compatible: Yes
Ambidextrous: Yes
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs

This one piece picatinny mount for the Savage 99 is a great addition to your favorite lever action hunting rifle. The one piece base allows you to mount modern scope rings and a modern scope on your Savage 99.

EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.

EGW machines these in their shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type III anodized for long lasting durability.

Installation: EGW recommend 20 inch lbs of torque and a drip of blue loctite.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.


CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Browse Similar Items

Recently Viewed Items