Mounting Hardware is Included
This mount fits:
Ruger Precision Rifle (RPR) Magnum
This mount will not work on:
Ruger Precision Rimfire
Ruger Precision Non Magnum
Rail Type: One Piece Picatinny
Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Hardcoat
Center Spread: 2.314
Overall Length of Mount: 8.040"
Height: .575" (Top of Receiver to Top of Picatinny)
Weight: 2.5 oz
Quick Disconnect Ring Compatible: Yes
Ambidextrous: Yes
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: #8-40 X 1/4 Screws and T-10 Wrench Included
Torque Specs: 20 in/lbs
EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
EGW machines these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type III anodized for long lasting durability.
EGW recommends:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
30 MOA - if shooting 1000-1500 yards
40 MOA - if shooting 1500+ yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Installation: We recommend 20 inch lbs of torque and a drip of blue loctite.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/ 