This mount is made specifically for the Tikka T3x Tac A1.
There is a screw in the front of the original mount that is located underneath the handguard. The handguard must be removed and then this screw must also be removed before the original mount can be removed.
Removing the original mount may be a difficult task. Please use caution when removing the original mount and when installing EGW's mount. We always recommend having EGW's products installed by a competent and qualified gunsmith.
Metric screws are only available with hex heads.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".
After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
Compatible with Picatinny or Weaver scope rings. Add EGW’s HD Scope Rings to make it a complete package!
From manufacturing to packaging, EGW’s products are made with pride in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.