This mount does not work on the PH actions.
Rail Type: One Piece Picatinny
Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Hardcoat
Center Spread: 4.045"
Overall Length of Mount: 7.458"
Height: .35" (Top of Receiver to Top of Picatinny)
Weight: 2.5 oz
Quick Disconnect Ring Compatible: Yes
Ambidextrous: Yes
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs
This mount comes standard with a bevel on both sides making it ambidextrous.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
These bases sit at approximately 0.35" high.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".
After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
Compatible with Picatinny or Weaver scope rings. Add EGW's HD Scope Rings to make it a complete package!
From manufacturing to packaging, EGW's products are made with pride in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
When zeroing your rifle with a 20 MOA mount, EGW recommends zeroing at 200 yards.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/ 