0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Savage
  5. Rifle Scope Mounts
  6. EGW Steel HD Savage Long Action Round Back Picatinny Rail Scope Mount 20 MOA Ambidextrous
EGW Steel HD Savage Long Action Round Back Picatinny Rail Scope Mount 20 MOA Ambidextrous
EGW Steel HD Savage Long Action Round Back Picatinny Rail Scope Mount 20 MOA Ambidextrous

EGW Steel HD Savage Long Action Round Back Picatinny Rail Scope Mount 20 MOA Ambidextrous

Write a Review
Price: $119.00
EGW Evolution Gun Works makes scope mounts and scope bases for most popular rifles in 0 MOA, 20 MOA, 30 MOA, and 40 MOA. Put a scope on your favorite rifle with a quality mount Made In The USA.
Part Number: 86302
Availability:
Machined From: 4140 Carbon Steel
Finish: Parkerized
Compatible with Picatinny or Weaver scope rings. 
Mounting Hardware: Socket Head Torx® Screws and Wrench Provided
Center Spread: 4.63"
Overall Length of Mount: 7.458"

Due to the change in which receivers have #6 and #8 screws from Savage, we recommend you remove and measure one of the screws prior to purchasing our scope mount. This mount comes with #6 screws. 

Rifles requiring #8 screws & Mount does NOT fit (please check your individual rifle to be sure):
10/110 BA Stealth
10/110 Stealth Evolution
110 Scout
110 Wolverine
10 GRS
110 Tactical
110 Tactical LH
110 Tactical Desert

Screw Diameters
#6 Screws - .013" diameter (Screws With This Mount)
#8 Screws - .016" diameter

EGW's HD Savage bases will work with any long action round back Savage rifle. 

The round back on this mount will accommodate rounded receivers, and guns that have an accu-trigger. 

Savages without an accu-trigger will require our flat back mount (listed separately). Our mount is drilled for and provided with 6-48 Torx Head screws. Some Long Action Savage guns (like the .338 Lapua or 110 BA) require 8-40 screws. 

These bases sit at approximately 0.35” high.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".

After machining; the mounts are sand blasted. The steel rails are Mil Spec parkerized for a durable rust resistant finish. 

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

Compatible with Picatinny or Weaver scope rings. Add EGW’s HD Scope Rings to make it a complete package! 

From manufacturing to packaging, EGW’s products are made with pride in the USA.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.


CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Recently Viewed Items