Scout Mount
Fits Mosin Nagant 91/30 & 91/59
Weaver Base
Accepts Weaver Rings (Not Included)
No alteration needed
Scope Not Included
Made In The USA!!!
Didn’t think it was possible to easily put a scope and mount on your old Mosin Nagant 91/30 & 91/59 without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!
Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.
For Instant Scope Mounting of Ex-Military Firearms. No Drilling or Tapping Required
S&K INSTA MOUNT BASES
The BEST WAY to mount a scope on your ex-military rifle. WHY?
-No major alteration to your valuable firearm
-No drilling or tapping of the ultra-hard receiver
-Handsome ruggedness
-Guaranteed to hold zero
-Low cost for a quality product made in the USA!
-Unmatched versatility
-Can be removed and/or reinstalled easily
-Fast service
-Made In The USA
#9170 INSTRUCTION SHEET FOR THE MOSIN NAGANT
PUSH THE PIN OUT AT THE FRONT OF THE REAR FLIP UP SIGHT. REMOVE THE SPRING BY SLIDING IT FORWARD AND LIFTING IT OUT. SLIDE THE FLANGE NUT INTO THE UNDERNUT AT THE REAR OF THE SIGHT WHERE THE SPRING WAS. PLACE THE MOUNT OVER THE FLANGE NUT WITH THE (2) 4-40 TAPPED HOLES TOWARD THE BARRELL END. LINE THE 4-40 HOLES IN THE MOUNT UP WITH THE HOLES IN THE SIDE OF THE RECEIVER AND PUT IN THE (2) 4-40 SOCKET HEAD CAP SCREWS. DO NOT TIGHTEN!!!
PLACE A PIN, DRILL,ETC . THROUGH THE COUNTERSUNK HOLE IN THE TOP OF THE MOUNT AND INTO THE HOLE IN THE SPECIAL NUT & MOVE THE NUT AROUND WITH THE PIN UNTIL THE ROUND PART OF THE NUT SLIPS INTO THE COUNTERBORE IN THE BOTTOM OF THE MOUNT. PUT THE 10-32 X 1/2 FLAT HEAD SCREW THROUGH THE MOUNT AND INTO THE NUT. TIGHTEN THIS SCREW AND THE (2) 4-40 SCREWS. PUT THE 10-32 x ½ SET SCREW DOWN THROUGH THE FRONT TAPPED HOLE IN THE TOP OF THE MOUNT AND TIGHTEN AGAINST THE RECEIVER. PUT THE 10-32 x 5/16 SET SCREW INTO THE REAR TAPPED HOLE & TIGHTEN. THIS SCREW CAN BE USED FOR SOME VERTICAL ADJUSTMENT. IF YOU FIND YOUR GUN IS SHOOTING LOW, LOOSEN THE 10-32 FLATHEAD, TIGHTEN THE 10-32 x 5/16 SET SCREW AND RE-TIGHTEN THE 10-32 FLATHEAD. FOR EVERY ¼ TURN OF THE SET SCREW YOU WILL MOVE APPROXIMATELY 8” AT 100 YARDS.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/
