Fits Winchester mod 70 long action rifles with 7.570 inch action screw spacing. This stock uses a blind bottom magazine box. Will not fit the Winchester Pre.64 actions.
DESIGNED BY MAJ. JOHN PLASTER U.S. ARMY( RET.) Author of “The Ultimate Sniper: An Advanced Training Manual for Military and Police Snipers”
The heart of the stock is the Aluminum bedding block with pressed in Aluminum pillars. The rifle only touches the bedding block and not the stock. Designed to fit barrels up to 1.25 inches. The stock comes with an adjustable butt pad that has a range of adjustment of one inch up and one inch down from center and uses spacers to adjust the length of pull. The stock comes with one half inch spacer. You can order more spacers to increase the length of pull up to 1 1/4 inches over what comes on the stock which is 13 3/4 of an inch. Also included with the stock are two different cheek pieces that are .650 tall and .900 tall. There are three mounting points on the top of the stock so you can adjust the position of the cheek piece to suit your need. The bottom of the front of the stock has a rail system that allows the use of different adaptors to mount a bipod to the front of the stock. The stock comes with a quick detach adaptor part # 22-05-02 that works with most Harris bipods. Among the many features of the stock are the side mounted sling loops that allow you to carry the rifle flat on you back to protect the scope. The mono pod at the butt end of the stock makes a solid three point shooting platform.
Made in The USA