0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. SKS
  5. Scope Mounts
  6. S&K SKS DT 465 Scope Mount w/S&K Style 1 Inch Rings
S&K SKS DT 465 Scope Mount w/S&K Style 1 Inch Rings
S&K SKS DT 465 Scope Mount w/S&K Style 1 Inch Rings

S&K SKS DT 465 Scope Mount w/S&K Style 1 Inch Rings

Write a Review
Price: $74.00
This SKS mount is a rock solid scope mount for your SKS rifle. Bring your vintage rifle into the present with optics for better accuracy, longer ranges, more confidence, and more fun hunting or on the range! Made In The USA.
Part Number: DT465
Availability:

Drilling and tapping required

Includes 1 Inch S&K Style Rings

Scope Not included

Made In The USA!!!


Didn’t think it was possible to easily put a scope and mount on your old SKS rifle? It is now with a high quality, made in the USA scope mount from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Now you can scope that rifle you didn't think was possible with over 100 Insta-Mounts & Scout Mounts to choose from. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.

For Instant Scope Mounting of Ex-Military Firearms.

 

S&K INSTA MOUNT BASES

The BEST WAY to mount a scope on your ex-military rifle. WHY?

-Handsome ruggedness

-Guaranteed to hold zero

-Low cost for a quality product made in the USA!

-Unmatched versatility

-Can be removed and/or reinstalled easily

-Fast service

-Made In The USA

ADVANTAGES OF S&K MOUNTING SYSTEM

-Front and rear rings are interchangeable

-Ring studs mate to matching receptacles in bases

-BOTH rings bear against front of their respective receptacles (both absorb recoil shock)

-Trim in appearance, light in weight

-Precision bored – scope will not slip

-No knobs, bolts or other obtrusions to break or bend

-Fit any 1 inch scope tube

All S&K rings are fully machined out of solid steel bar stock, tumble finished to remove all burrs, and have a 3/8" diameter stud that locks into a 3/8" hole or slot in the base which provides windage adjustment. The rings are locked into position by tightening cooperative cone pointed set screws. The rings are precision bored to 1" diameter and, being machined rather than extruded or stamped, form a precision fit that will not slip under recoil. They are nicely contoured and trim in appearance. S&K rings are tumble finished and blued to achieve a military-type dull or nonglare black finish that matches the black anodized Insta Mount bases.


Instruction sheet for SKS DT 465

To install the new SKS DT 465 mount, simply place the side plate on left side of receiver in proper location, mark the holes with a center punch, drill and tap 3 holes (6-40) and install the side plate. Bolt the top plate to it, with projection forward. Install rings according to instructions on the box, and you are ready to install the scope of your choice.


CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Related Items

Recently Viewed Items