Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Only
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: Socket Head Torx® Screws and Wrench Provided
Center Spread: 4.63"
Overall Length of Mount: 7.458"
This HD Savage base will work with any long action round back Savage rifle that is drilled for #8 screws. We supply T-10 #8-40 screws.
The round back on this mount will accommodate rounded receivers, and guns that have an accu-trigger.
Savages without an accu-trigger will require our flat back mount (listed separately). Our mount is drilled for and provided with 8-40 Torx Head screws. Some Long Action Savage guns (like the .338 Lapua or 110 BA) require 8-40 screws. This mount will work for the Savage 112.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
These bases sit at approximately 0.35” high.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".
After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
Compatible with Picatinny or Weaver scope rings. Add EGW’s HD Scope Rings to make it a complete package!
From manufacturing to packaging, EGW’s products are made with pride in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.