This mount is made specifically for the Tikka T3.
T3x Superlite Camo
T3x Lite Stainless
T3x Compact Tactical Rifle
T3x Laminated Stainless
T3x Hunnter Stainless
T3 Laminated Stainless
T3 Super Varmint
T3 Varmint Stainles
T3 Compact Tactical
Modification to the front of the mount is required to fit the Tikka T3X Tac A1. The mount must be cut down to fit behind the forend. Our mount is not the same height as the forend.
Our mount does not have a recoil lug.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
These bases sit at approximately 0.35” high.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".
After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Compatible with Picatinny or Weaver scope rings. Add EGW’s HD Scope Rings to make it a complete package!
From manufacturing to packaging, EGW’s products are made with pride in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.