Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Silver Anodized
Mounting Hardware: Hex head screws and wrench provided
Overall Length: 4.3"
This mount fits:
GP100 (with adjustable rear sights)
GP100 Match Champion
This rail mounts using the hole from your rear sight, but also requires you to drill and tap two additional holes in your receiver if your gun is not already drilled and tapped.
The mount is also available undrilled to accommodate unconventional bolt patterns. See item number 49006.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike. This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!
We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.