Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Silver Anodized
Mounting Hardware: Hex head screws and wrench provided
Center Spread: 4.630"
Overall Length: 7.458"
This mount does NOT fit the 212
Our Savage bases will work with any long action round back Savage rifle with an ejection port.
The round back on this mount will accommodate rounded receivers, and guns that have an accu-trigger.
Savages without an accu-trigger will require our flat back mount (listed separately).
The middle spread is the distance between the two middle holes, center to center, on your receiver.
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
Our mount is drilled for and provided with 6-48 Hex Head screws. Some Long Action Savage guns (like the .338 Lapua or 110 BA) require 8-40 screws. We recommend the HD Savage Round Back Long Action part #80330 or #80332 for these. Our mount is counter-sunk for 8-40 screws.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories.
The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights.
EGW's one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
Add EGW's Practical or HD Scope Rings to make it a complete overhaul!
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.