Machined From: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Only
Mounting Hardware: Hex Head Screws and Wrench Provided
Center Spread: 4.275"
Overall Length of Mount: 6.670"
*The center spread is the distance between the two middle holes, center to center, on your receiver.
This mount is specifically for the Swedish Mauser with the stripper clip hump. This mount comes standard with a bevel on both sides making it ambidextrous.
All bases sit at approximately 0.4" high.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike. This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!
We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.