0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Enfield
  5. S&K #1 Mark III Scout Mount Weaver Style (No Rings Included)
S&K #1 Mark III Scout Mount Weaver Style (No Rings Included)
S&K #1 Mark III Scout Mount Weaver Style (No Rings Included)

S&K #1 Mark III Scout Mount Weaver Style (No Rings Included)

Write a Review
Price: $74.00
Use this Weaver base to add a long eye relief scope to your old military Lee Enfield rifle. Made In the USA.
Part Number: MK70
Availability:

Drilling & Tapping Required

Scout Mount

Attaches To Rear Sight

Scope & Rings Not Included

Weaver Base

Accepts Weaver Rings (Not Included)

Does NOT fit Ishapore 2A1 800 meter sight. Will fit 2A sight.

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old Lee Enfield? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.


INSTRUCTION SHEET FOR THE #1 MARK lll #MK70

Push the pin out at the rear of the rear flip up sight. Remove the flip up sight & the spring by sliding it forward and lifting it out. Use the 6-40 bottom tap supplied with this mount & tap the existing threaded hole in the receiver to maximum depth. If you don’t have some experience with tapping holes we recommend you have a gunsmith or machinist tap the hole for you as the tap is almost impossible to get out when broken. The hole must be tapped straight & to maximum depth. Place the mount into the rear sight area & align the 6-32 tapped holes in the mount up with the holes in the side of the receiver where the pin was removed. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Put in the (2) 6-32 x ? socket head screws. Do not tighten!!!

Put the 6-40 x 5/16 fillister head screw through the mount and into the tapped hole in the receiver. Lightly tighten the (2) 6-32 socket head screws. They DO NOT need to be real tight. Put the 10-32 x ? set screw down through the tapped hole in the top of the mount and tighten against the receiver. The purpose of this set screw is to keep pressure on the 6-32 socket head screws so they can’t back out & keep down pressure on the rear of the mount.

Recently Viewed Items