0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Old Military Rifle Scope Mounts
  5. S&K 1891 Argentine Scout Mount (Weaver Style)- Rings Not Included
S&K 1891 Argentine Scout Mount (Weaver Style)- Rings Not Included
S&K 1891 Argentine Scout Mount (Weaver Style)- Rings Not Included

S&K 1891 Argentine Scout Mount (Weaver Style)- Rings Not Included

Write a Review
Price: $74.00
This is a solid scout mount for an 1891 Argentine Mauser. Add a long eye relief scope and bring your vintage rifle into the present. Made In The USA!!
Part Number: ARG80
Availability:

Does NOT fit Carbine or 1909

Weaver Base

Accepts Weaver Rings (Not Included)

Scope Not Included

Made In The USA

Didn’t think it was possible to easily put a scope and mount on your old 1891 Argentine Scout Mount without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.


INSTRUCTION SHEET FOR THE ARGENTINE 1891 #ARG80


Remove the receiver & barrel from the wood. Push the pin out at the rear of the rear flip sight. Remove the flip up sight & then the spring by first taking the small screw that holds the spring in place, slide it forward and lift it out. Slide the flange nut into the undercut at the front of the sight where the spring was with the full radius on the nut toward the rear. Place the mount over the special nut & align the 4-40 tapped holes in the mount up with the holes in the side of the receiver. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Put in the (2) 4-40 x ? socket head screws. Do not tighten!!!

Put the 10-32 x 3/8 flat head screw through the mount and into the nut & tighten. Lightly tighten the (2) 4-40 socket head screws. They DO NOT need to be real tight. Put the 10-32 x ? set screw down through the tapped hole in the top of the mount and tighten against the receiver. The purpose of this set screw is to keep pressure on the 4-40 socket head screws so they can’t back out.


Recently Viewed Items