Also Fits Spanish and Brazilian 1934
Weaver Style Base/ Accepts Weaver Rings
No Alterations Needed
Rings Not Included
Scope Not Included
Made In The USA!!!
Didn’t think it was possible to easily put a scope and mount on your old 98K, Spanish, or Brazilian 1934 without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!
Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.
For Instant Scope Mounting of Ex-Military Firearms. No Drilling or Tapping Required
S&K INSTA MOUNT BASES
The BEST WAY to mount a scope on your ex-military rifle. WHY?
-No major alteration to your valuable firearm
-No drilling or tapping of the ultra-hard receiver
-Handsome ruggedness
-Guaranteed to hold zero
-Low cost for a quality product made in the USA!
-Unmatched versatility
-Can be removed and/or reinstalled easily
-Fast service
-Made In The USA
INSTRUCTION SHEET FOR MAUSER 98K SCOUT, #2675, & 2680
Remove the rear sight from the rifle. Keep the S&K mount centered over the rear sight area & at the same time slide the bottom foot of the mount into the undercut at the rear while pushing down on the front. You may need to tap the mount lightly back into the undercut. The two tapped side holes in the mount need to line up with the holes in the receiver where the pin was removed. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Install the two 6-32 screws through the holes where the pin was removed & into the S&K mount. LIGHTLY TIGHTEN THESE TWO SCREWS & DO NOT RETIGHTEN. Center the mount at the rear & install the 10-32 x ½” sets screws into the top of the mount & tighten. You can adjust windage some by loosening the 10-32 set screws & moving the rear of the mount sideways & retighten. WHEN REMOVING THE MOUNT DO NOT TRY TO REMOVE THE TWO 6-32 SCREWS UNTIL LOOSENING THE SET SCREWS ON TOP OF THE MOUNT.
CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/
