Fits Weaver Rings NOT INCLUDED
All Mounts marked S&K Style Rings do NOT
work with Weaver Rings
Scope Not Included
Made In The USA!!!
#9565 Pictured. #9570 is a Weaver base and rings NOT included. Otherwise, mounts are the same.
Didn’t think it was possible to easily put a scope and mount on your old Budapest M95 Mauser without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!
Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.
INSTRUCTION SHEET FOR BUDAPEST MAUSER M95 SCOUT MOUNT # 9565 and # 9570
Remove the rear sight by pushing the pin out. Push down on the flip-up sight & slide rearward. Remove the spring. Slide the special nut into the grove at the rear of the sight. Place the mount into the rear sight with the bottom hole over the special nut and the (2) side holes to the front of the gun. Put the 10-32 x ¾ (for #9565) or 10-32 x 5/8 (for #9570) flathead screw through the mount and into the special nut. (Do not tighten at this time) Line the 6-32 tapped holes (in side of the mount) up with the holes in the side of the receiver. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Insert the (2) 6-32 x 5/16 socket head cap screws through the hole the pin was in and into the mount. Lightly tighten the (2) 6-32 screws. Tighten down the 10-32 x ¾ (for #9565) or 10-32 x 5/8 (for #9570) flathead screw and then the (2) 6-32 x 5/16 socket head cap screws. You don’t need to get the (2) 6-32 screws very tight! Insert the 10–32 x ½ set screw into the front top hole & snug down. Insert the 10–32 x 3/8 set screw into the rear top hold & snug down. Re-tighten the 10-32 x ½ set screws. After you have tightening the 10-32 set screws – Do not try to tighten or loosen the 6-32 side screws as the top set screws hold pressure on the 6-32 screws. Mount the scope & determine how much the rear of the scope needs raised. Remove the scope, loosen the 10-32 flat head screw & tighten the rear 10-32 set screw to raise the rear of the scope to the correct height. Retighten the 10-32 flat head screw. Repeat this procedure until the scope is sighted in.