0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Mauser
  5. Scope Mounts
  6. S&K CZ24 Czechoslovakian Mauser Scout Mount (S&K Style) w/S&K Style 1 Inch Rings
S&K CZ24 Czechoslovakian Mauser Scout Mount (S&K Style) w/S&K Style 1 Inch Rings
S&K CZ24 Czechoslovakian Mauser Scout Mount (S&K Style) w/S&K Style 1 Inch Rings

S&K CZ24 Czechoslovakian Mauser Scout Mount (S&K Style) w/S&K Style 1 Inch Rings

Write a Review
Price: $91.00
This CZ24 Czechoslovakian Mauser scout mount will mount a long eye relief scope to the rear sight of your old military rifle. Made with pride in the USA.
Part Number: CZ24
Availability:

Scout Mount

Replaces Rear Sight

Will also fit the VZ 24. Can Fit Rashid if you shave a little off nut.

Includes S&K Style 1 Inch Rings

Scope not Included

No alteration needed

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old CZ24 Czechoslovakian Mauser, VZ 24, or Rashid without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.


#CZ 24 Instruction Sheet for the CZ24 Scout Mount

Remove the rear sight by pushing the hinge pin out and then remove the sight and spring.

Center the mount over the rear sight area and the same time slide the bottom of the mount into the undercut at the rear while pushing down on the front. You may need to tap the mount lightly back into the receiver where the pin was removed. Install the two 6-32 x 5/16 screws into the pin holes of the mount. Place the two 10 – 32 x ½ set screws into the holes provided and tighten.


Recently Viewed Items