0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Mauser
  5. Scope Mounts
  6. S&K Chilean 1895 And Spanish 1893 Scout Mount  (Weaver Style) -Accepts Weaver Rings- Rings NOT Included

S&K Chilean 1895 And Spanish 1893 Scout Mount  (Weaver Style) -Accepts Weaver Rings- Rings NOT Included

1 Review(s) Write a Review
Price: $74.00
This rock solid scout mount that will accept a long eye relief scope for better accuracy of your old military Chilean 1895 And Spanish 1893 Mauser. Made with pride in the USA.
Part Number: 1890
Availability:

Scout Mount

Fits Chilean 1895 And Spanish 1893 

Weaver Style Base

Accepts Weaver Rings (Not Included)

Rings And Scope Not Included

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old Chilean 1895 or Spanish 1893 Mauser without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.


#1890 INSTRUCTION SHEET FOR THE CHILEAN 1895 AND 1893 SPANISH


Push the pin out at the rear of the flip up sight. Remove the top wood over the barrel. Remove the spring by lifting up at the rear and sliding it forward. Slide the flange nut into the undercut at the front of the sight where the spring was & re-install the top wood cover. Orientation not important. Place the mount over the flange nut with the (2) 4-40 tapped holes toward the butt end. Line the 4-40 tapped holes in the mount up with the holes in the side of the receiver and put in the (2) 4-40 x 3/8 socket head screws.  It is very important that these holes line up to keep from damaging the threads when the screws are installed. DO NOT TIGHTEN! Move the nut around with a pin through the hole in the mount until the round part of the nut slips into the counterbore in the bottom of the mount. Put the 10-32 x ½”  flat head screw through the mount and into the nut. Tighten this screw and then the (2) 4-40 socket head screws. The 4-40 screws don’t need to be real tight! Put the 10-32 x ½ set screw down through the tapped hole in the top of the mount and tighten against the receiver. The purpose of the set screws is to keep pressure on the 4-40 socket head screws. Do not try to remove the 4-40 screws with the set screw tight!


Recently Viewed Items