Scout Mount
Replaces Rear Sight
Includes S&K Style 1 Inch Rings
Scope not included
No alteration needed
Made In The USA!!!
Didn’t think it was possible to easily put a scope and mount on your old Czechoslovakian 98/22 Mauser without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!
Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.
#CZ65 INSTRUCTION SHEET FOR CHECHSLOVAKIAN 98/22 SCOUT
Remove the rear sight from the gun by pushing the hinge pin out & removing the flip up sight & spring. Keeping the special nut supplied with the mount centered in the rear sight, slide it all the way to the rear of the sight. It will slide under a ledge where the spring was. Center the mount over the rear sight with the two 6-32 screw holes in the side toward the front of the gun. Lower the mount into the rear sight area. Line the 6-32 tapped holes in the mount up with the holes in the side of the receiver. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Install the two 6-32 x 5/16th flat head screws in these two holes. Snug them down but do not tighten real tight. They don’t need to be very tight! Insert the 10-32 x ¾ flat head screw into the mount & tighten. Insert the 10-32 x ½ set screw into the mount & tighten. Re-tighten the flathead screw.
