0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Mauser
  5. Scope Mounts
  6. S&K Husqvarna Mauser 38 Scout Mount (S&K Style)  w/S&K Style 1 Inch Rings

S&K Husqvarna Mauser 38 Scout Mount (S&K Style)  w/S&K Style 1 Inch Rings

Write a Review
Price: $84.00
This Husqvarna Mauser 38 scout mount will mount a long eye relief scope to the rear sight of your old military rifle. Made with pride in the USA.
Part Number: HU65
Availability:

Scout Mount

Replaces Rear Sight

Includes S&K Style 1 Inch Rings

Scope Not included

No alteration needed

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old Husqvarna Mauser 38 Scout without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.

#HU65 INSTRUCTIONS SHEET FOR HUSQVARNA SCOUT
Remove the rear sight ladder by pushing the hinge pin out with a 1/16” punch. Remove the leaf spring by sliding it forward (a strike with a punch & hammer might be required to dislodge it). Slide the special nut (with the short part of the head toward the rear) into the spring slot & all the way toward the rear of the slot. Set the S&K mount over the rear sight so the screw holes in the front of the S&K mount line up with the horizontal hinge pin holes in the rifle. Align the rear hole in the top of the S&K mount up with the special nut. It is very important that these holes all line up to keep from damaging the threads when the screws are installed. Put the two 4-40 x 5/16th socket head screws through the hinge pin holes in the receiver & into the tapped side holes in the mount. Do not tighten at this time. Put the 10-32 x ¾” flat head screw through the hole in the top of the mount & into the special nut but do not tighten. Now tighten the 4-40 socket head screws - You don’t need to get the (2) 4-40 screws very tight! Now tighten the 10-32 flat head screw. Screw the 10-32 x ½” socket set screw into the top of the mount in the front and the 10-32 x 3/8 screw in the rear and tighten both. This will hold upward pressure on the mount, eliminating any movement in the mount & locking the 4-40 screws in place. Do not try to tighten or loosen the 4-40 screws with the 10-32 set screw tight as you will damage or break the 4-40 screws.

Recently Viewed Items