0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. M1 Carbine
  5. Scope Mounts
  6. S&K M1 Carbine Scope Mount-Accepts Weaver Rings- Rings NOT Included
S&K M1 Carbine Scope Mount-Accepts Weaver Rings- Rings NOT Included
S&K M1 Carbine Scope Mount-Accepts Weaver Rings- Rings NOT Included

S&K M1 Carbine Scope Mount-Accepts Weaver Rings- Rings NOT Included

4 Review(s) Write a Review
Price: $80.00
This M1 Carbine mount is a rock solid scope mount for your rifle. Bring your vintage rifle into the present with optics for better accuracy. Made In The USA.
Part Number: 1070

Fits any manufacturer

Replaces rear sight

No Other Work Required

Does NOT Include Scope

Fits Weaver Rings NOT INCLUDED

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old M1 Carbine without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

S&K Scope Mounts LLC specializes in manufacturing scope mounts for ex-military rifles without the need for drilling & tapping. Now you can scope that rifle you didn't think was possible with over 100 Insta-Mounts & Scout Mounts to choose from. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.

For Instant Scope Mounting of Ex-Military Firearms. No Drilling or Tapping Required


The BEST WAY to mount a scope on your ex-military rifle. WHY?

-No major alteration to your valuable firearm

-No drilling or tapping of the ultra-hard receiver

-Handsome ruggedness

-Guaranteed to hold zero

-Low cost for a quality product made in the USA!

-Unmatched versatility

-Can be removed and/or reinstalled easily

-Fast service

-Made In The USA


We would like to congratulate you for your choice of an S&K insta mount and assure you that we guarantee a properly installed insta mount to be as strong and in most cases stronger than any other mount. To properly install your mount simply do the following:

Drive the rear sight out of it’s dovetail in the carbine receiver (Drive left to right), and replace the sight with the dovetail nut included with the insta mount. Put the base in proper location on top of the receiver with mount projection forward. Put cap screw in place and tighten as tight as possible. (DO NOT USE AN EXTENSION ON KEY) 

CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Related Items

Recently Viewed Items