0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Mauser
  5. Scope Mounts
  6. S&K Mosin Nagant 91/30 & 91/59 Scout Mount -Accepts Weaver Rings- Rings NOT Included

S&K Mosin Nagant 91/30 & 91/59 Scout Mount -Accepts Weaver Rings- Rings NOT Included

Write a Review
Price: $74.00
This Mosin Nagant 91/30 & 91/59 scout mount will allow you to mount a long eye relief scope to the rear sight of your old military rifle. Made with pride in the USA.
Part Number: 9170
Availability:

Scout Mount

Fits Mosin Nagant 91/30 & 91/59

Weaver Base

Accepts Weaver Rings (Not Included)

No alteration needed

Scope Not Included

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old Mosin Nagant 91/30 & 91/59 without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available. 


#9170 INSTRUCTION SHEET FOR THE MOSIN NAGANT

PUSH THE PIN OUT AT THE FRONT OF THE REAR FLIP UP SIGHT. REMOVE THE SPRING BY SLIDING IT FORWARD AND LIFTING IT OUT. SLIDE THE FLANGE NUT INTO THE UNDERNUT AT THE REAR OF THE SIGHT WHERE THE SPRING WAS. PLACE THE MOUNT OVER THE FLANGE NUT WITH THE (2) 4-40 TAPPED HOLES TOWARD THE BARRELL END. LINE THE 4-40 HOLES IN THE MOUNT UP WITH THE HOLES IN THE SIDE OF THE RECEIVER AND PUT IN 

THE (2) 4-40 SOCKET HEAD CAP SCREWS. DO NOT TIGHTEN!!!

PLACE A PIN, DRILL,ETC . THROUGH THE COUNTERSUNK HOLE IN THE TOP OF THE MOUNT AND INTO THE HOLE IN THE SPECIAL NUT & MOVE THE NUT AROUND WITH THE PIN UNTIL THE ROUND PART OF THE NUT SLIPS INTO THE COUNTERBORE IN THE BOTTOM OF THE MOUNT. PUT THE 10-32 X 1/2 FLAT HEAD SCREW THROUGH THE MOUNT AND INTO THE NUT. TIGHTEN THIS SCREW AND THE (2) 4-40 SCREWS. PUT THE 10-32 x ½ SET SCREW DOWN THROUGH THE FRONT TAPPED HOLE IN THE TOP OF THE MOUNT AND TIGHTEN AGAINST  THE RECEIVER. PUT THE 10-32 x 5/16 SET SCREW INTO THE REAR TAPPED HOLE & TIGHTEN. THIS SCREW CAN BE USED FOR SOME VERTICAL ADJUSTMENT. IF YOU FIND YOUR GUN IS SHOOTING LOW, LOOSEN THE 10-32 FLATHEAD, TIGHTEN THE 10-32 x 5/16 SET SCREW AND RE-TIGHTEN THE 10-32 FLATHEAD . FOR EVERY ¼ TURN OF THE  SET SCREW YOU WILL MOVE APPROXIMATELY 8” AT 100 YARDS.


Recently Viewed Items