Does NOT fit Lang Vizier Rear Sight
Weaver Base
Accepts eaver Rings (Not Included)
Rings And Scope Not Included
Made In The USA!!!
Didn’t think it was possible to easily put a scope and mount on your old Spanish 1916 Mauser without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!
Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.
#SP70 INSTRUCTION SHEET FOR THE 1916 SPANISH MAUSER
Push the side pin out of the rear flip up sight and remove the spring by sliding it forward and lifting it out.
Slide the flange nut into the undercut at the rear of the sight where the spring was. Place the mount over the
flange nut, line the side hole in the mount up with the holes in the side of the receiver and push in the pin you removed from the flip up sight. Place a pin, drill, etc. through the countersunk hole in the top of the mount and into the hole in the special nut and move the nut around with a pin until the round part of the nut
slips into the counterbore in the bottom of the mount. Put the 10-32 x ½ flat head screw through the mount and into the nut and tighten this screw. Put the 10-32 x ½ set screw down through the front tapped hole in the top of the mount and tighten against the receiver. This screw puts pressure against the pin thus removing any play in the mount.
Select a row below to filter reviews.
5.0