0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Mauser
  5. Scope Mounts
  6. S&K Steyr M95 Carbine Scout Mount (Short Ladder Weaver Style) Also will fit Budapest & Austrian M34 Stutzen -Accepts Weaver Rings- Rings NOT Included
S&K Steyr M95 Carbine Scout Mount (Short Ladder Weaver Style) Also will fit Budapest & Austrian M34 Stutzen -Accepts Weaver Rings- Rings NOT Included
S&K Steyr M95 Carbine Scout Mount (Short Ladder Weaver Style) Also will fit Budapest & Austrian M34 Stutzen -Accepts Weaver Rings- Rings NOT Included

S&K Steyr M95 Carbine Scout Mount (Short Ladder Weaver Style) Also will fit Budapest & Austrian M34 Stutzen -Accepts Weaver Rings- Rings NOT Included

2 Review(s) Write a Review
Price: $80.00
This is a rock solid scout mount for your old Steyr M95 Carbine Short Ladder, Budapest or Austrian M34 Stutzen Mauser without drilling and tapping. Made in the USA.
Part Number: 8070
Availability:
Steyr M95 Carbine Scout Mount-Short Ladder Weaver Style

Also will fit Budapest & Austrian M34 Stutzen

Weaver Style Base

Accepts Weaver rings(Not Included)

Made In The USA

Didn’t think it was possible to easily put a scope and mount on your old Steyr M95 Carbine Short Ladder, Budapest or Austrian M34 Stutzen without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.


For Instant Scope Mounting of Ex-Military Firearms. No Drilling or Tapping Required

 

S&K INSTA MOUNT BASES

The BEST WAY to mount a scope on your ex-military rifle. WHY?

-No major alteration to your valuable firearm

-No drilling or tapping of the ultra-hard receiver

-Handsome ruggedness

-Guaranteed to hold zero

-Low cost for a quality product made in the USA!

-Unmatched versatility

-Can be removed and/or reinstalled easily

-Fast service

-Made In The USA



#8070 Instruction sheet for Styer M95 Carbine (Short Ladder Sight) (Also Budapest & Austrian M34 Stutzen)

To install this mount, it is necessary to remove the rear sight from your Styer. You will need to first remove the top wood piece in front of the rear sight. To remove the sight push out the pivot pin & remove the screw holding the spring in place.

After removal of the rear sight file off any burrs on the .096 diameter pivot pin you removed as this part will be reused. Insert the special tapered nut supplied with your S&K mount into the slot that the spring came out of. Place the bottom part of the S&K mount into the .314 wide slot at the rear of the receiver with the front hole on the underside over top of the special tapered nut. Slide the .096 diameter pivot pin into the hole on the receiver & then into the hole in the mount. Tap the pin in with a punch until it is flush with the side of the receiver. Put the 10-32 x ½ flathead screw down through the top of the mount & into the special tapered nut & tighten. Insert the10-32 x ½ socket set screw through the top of the mount & tighten.


CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Recently Viewed Items