0 Items
SKulptured scope bases fit each gun with the contour of the action and fits the radius and height of the barrel. Bases are model specific with rings to match your scope. These mounts are not blocky like traditional mounts and give your rifle a smooth, contoured look. These are perfect for your hunting rifle as they are light in weight, give the best solid mount, look great, and are Made In The USA! Your search for the best scope mount for your Winchester hunting rifle stops here. Click on the link at the bottom of this page to view the available scope base models.
Rifle Scope Bases And Rings
 Rifle Scope Mounts

Made In The USA!

Rifle Scope Bases And 1" or 30mm Rings - Matte

Sold with rings or bases alone.

The vertical rings work great:
S&K lock up is non-directional, and applies no torque to the scope tube. S&K has a V-groove that runs completely around the stud. The S&K ring stud fits into a slot that permits no forward movement of the ring stud, but moves left and right okay. In other words, the contact in this area on the S&K mount does not force the cone screws to absorb the recoil.
S&K Smooth Kontoured Scope Rings

Bases & Rings Available For:
-Winchester Model 70 Standard and Short Action, & Super Shadow
-Winchester Model 70 (Above 66350)
-Winchester Model 70 Magnum New Extension Mount
-Winchester Model 70 Magnum New Short Action
-Winchester Model 70 Magnum Old Pre 64
-Winchester Model 70 Very Early Model USE HIGH RINGS ONLY May Have To grind Bolt Handle
-Winchester Model 70 Classic Super Short
-Winchester Pre War 70 (High Rings Only Due To Bolt Handle)
-Winchester 52, 52D, 52B
-Winchester 88
-Winchester Low Wall
-Winchester High Wall
-Winchester 52C
-Winchester 54
-Winchester Super Short Mag

S&K is very proud of this scope mount as it represents the improvements of over 32 years of scope mount manufacture by their company. S&K guarantees this mount for your lifetime. If it fails for any reason other than deliberate destruction, S&K will replace it at no charge! It is handmade in their plant in the Pennsylvania hills by local craftsman who are proud of their work! 

There is no other all steel mount stronger or lighter! Average weight of complete all steel mount – 2 bases and 2 rings – is 3 oz! Windage is provided in both front and rear base and their patented Smooth Kontour rings are the easiest of all rings to install. 

Good looking? You bet! Cheap? No – they don’t make them of castings or powdered metal, but laboriously machine them from Virgin Bar stock. But the crisp, clean lines complement the finest rifles in the world. Yes, when you choose the S&K Skulptured mount with Smooth Kontour rings, you will know you have the finest available.
Scope Bases And Rings For Winchester Rifles

S&K offers these options for your mountings in matte.

S&K’S LOWEST 1" or 30mm SCOPE RINGS are approximately .125 high and place the bottom of the scope approximately .385 above the highest point of your rifle’s receiver when mounted in our lowest height Skulptured bases.

S&K'S MEDIUM 1" or 30mm SCOPE RINGS will raise the scope an additional .075 above S&K's lowest scope rings (Extra cost)

S&K’S HIGHEST 1" or 30mm SCOPE RINGS will raise the scope an additional .150 above S&K's lowest scope rings permitting scopes with up to 2-1/16 or 50 mm (Extra cost).

Made In The USA!
Click the below link to view SKulptured Scope Base for Winchester Rifles.
The SKulptured Scope Mount Bases are available for other gun manufacturers are well. Check out the full line at The Country Shed!

Click HERE to view Skulptured Scope Bases

1 Comments

Ken Gordon

Date 8/30/2023

The Country Shed

Date 8/31/2023

Add Comment