0 Items
  1. Home
  2. Manufacturers
  3. S&K Scope Mounts
  4. S&K Jap (99) Arisaka 7.7 Mauser Scout Mount
S&K Jap (99) Arisaka 7.7 Mauser Scout Mount
S&K Jap (99) Arisaka 7.7 Mauser Scout Mount

S&K Jap (99) Arisaka 7.7 Mauser Scout Mount

3 Review(s) Write a Review
Price: $75.00
Jap Arisaka 7.7 Mauser scout mount will mount a long eye relief scope to the rear sight of your old military rifle. Made with pride in the USA.
Part Number: JAP70

Will fit the 38

Will work on the 6.5 if it is NOT the carbine model. 

Will NOT fit the 44 Carbine

Scout Mount

Replaces Rear Sight

No Alterations Needed

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old Jap Arisaka 7.7 Mauser without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!
Check out S&K’s line of scout mounts available for ex-military guns! These mounts do not require any alterations to the rifle, just removal of the iron sights. A long eye relief scope (Not Included) is required for a scout mount. A nifty way to scope your treasured gun without drilling or tapping. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.

Remove the rear sight by pushing the hinge pin out & then remove the sight & spring. The spring is removed by tapping it toward the barrel end. You will have to first remove the wood cover. Slide the special nut into the slot the spring was removed from. The nut is tapered so insert the small side of the nut from the barrel end of the slot. Place the mount into the rear sight area aligning the two 4-40 screw holes where the hinge pin was removed. Insert the two 4-40 x 3/8 socket head screws into the mount & tighten lightly. Insert the 10-32 x 3/8 flat head screw into the mount & tighten. Insert the 10-32 x 3/8  set screw into the mount & tighten. 

Recently Viewed Items