0 Items
  1. Home
  2. Shop By Firearm
  3. Shop By Rifle
  4. Old Military Rifle Scope Mounts
  5. S&K MAS 36 - FRENCH Scope Mount (Weaver Style) -Accepts Weaver Rings- Rings NOT Included
S&K MAS 36 - FRENCH Scope Mount (Weaver Style) -Accepts Weaver Rings- Rings NOT Included
S&K MAS 36 - FRENCH Scope Mount (Weaver Style) -Accepts Weaver Rings- Rings NOT Included

S&K MAS 36 - FRENCH Scope Mount (Weaver Style) -Accepts Weaver Rings- Rings NOT Included

Write a Review
Price: $92.00
Add a receiver mount to your MAS36 with no alterations. This is a Weaver base that accepts any Weaver style rings. Rings are not included. Made In The USA.
Part Number: MAS36 (3670)

Does NOT fit 1967 Canadian Sentenial

No alterations needed- No modifications to the gun.

Weaver Style Base - Accepts Weaver Rings - Rings Not Included

Scope and Rings Not Included

Made In The USA!!!

Didn’t think it was possible to easily put a scope and mount on your old MAS 36 French without drilling and tapping? It is now with high quality, made in the USA scope mounts from S&K. These mounts are made with high quality materials and backed by S&K Scope Mounts. Outfit your old military rifle with a scope mount and long eye relief scope for better accuracy, longer ranges, more confidence, and more fun hunting or on the range!

S&K Scope Mounts LLC specializes in manufacturing scope mounts for ex-military rifles without the need for drilling & tapping. Now you can scope that rifle you didn't think was possible with over 100 Insta-Mounts & Scout Mounts to choose from. S&K Scope Mounts LLC supports American made. S&K manufactures all of their scope mounts here in PA with the best USA materials available.

For Instant Scope Mounting of Ex-Military Firearms. No Drilling or Tapping Required



The BEST WAY to mount a scope on your ex-military rifle. WHY?

-No major alteration to your valuable firearm

-No drilling or tapping of the ultra-hard receiver

-Handsome ruggedness

-Guaranteed to hold zero

-Low cost for a quality product made in the USA!

-Unmatched versatility

-Can be removed and/or reinstalled easily

-Fast service

-Made In The USA

Instruction sheet for Mas 36  #MAS36

To install this mount, it is necessary to remove the rear sight from your Mas 36.

After removal of the rear sight file any burrs off of the .098 diameter pivot pin you removed when taking off the rear sight. Place the right bottom part of the S&K mount into the .350 wide slot at the rear of the receiver. Slide the .098 pivot pin into the hole on the receiver & then into the hole in the mount (it will not fit in from the left side). Tap the pin in with a punch until it is flush with the right side of the receiver. Insert the (2) 10-32 x 1/2 socket set screws through the left side of the mount & VERY LIGHTLY tighten. Insert the 10-32 x 1/2 socket set screw down through the top of the mount at the rear & tighten. Tighten the (2) side screws.

CALIFORNIA RESIDENTS ONLY – WARNING: Some products may contain a chemical known to the State of California to cause cancer, or birth defects, or other reproductive harm. For more info, visit https://www.p65warnings.ca.gov/

Recently Viewed Items